Chronological Thread 

< Chronological >      < Thread >

---

Corey Sweeney wrote:

Good question! I always end up with tables that are so wide that the right hand columns don't print. Of course this usually means I should be desinging my tables better, but I'm interested in any solutions you hear to this.

Corey

On 6/8/06, Marten Bauer <address@hidden <mailto:address@hidden>> wrote:

Hallo,

in my current texmacs document I created a 'centered block' inside
a big
table.
The table is very large (about 3-4 pages) and has many cell spans...
When I print the document then the table isn't splitted to multiple
pages. The
first part of the table is printed over the page footers and the
rest is
missing.

How can configure teh table that it is printed to multiple pages
and on
every page
the table header will be repeated?

I'm afraid that in the current state of TeXmacs, one cannot
do tables which are bigger than a page (at least, it is my
experience, I'm not completely sure).

---

• Split big table to multiple pages?, Marten Bauer, 06/08/2006
  • Re: [TeXmacs] Split big table to multiple pages?, Corey Sweeney, 06/09/2006
    • Re: [TeXmacs] Split big table to multiple pages?, Henri Lesourd, 06/09/2006
      • Re: [TeXmacs] Split big table to multiple pages?, Javier Arantegui Jimenez, 06/10/2006
        • Re: [TeXmacs] Split big table to multiple pages?, Corey Sweeney, 06/10/2006

---

Archive powered by MHonArc 2.6.19.