- From: Jani Huhtanen <address@hidden>
- To: address@hidden
- Subject: Re: [TeXmacs] Inserting jpeg images
- Date: Fri, 28 Jul 2006 20:54:42 +0300
On Friday 28 July 2006 17:31, Ingolf Schaefer wrote:
>
Hi,
>
>
Jani Huhtanen schrieb:
>
> On Thursday 27 July 2006 21:34, David G. Wonnacott wrote:
>
>> Thanks for the diagnosis and recommendation. I re-ran ./configure and
>
>> looked for "jpeg", "jpg", and "image" in the output, but didn't see
>
>> _any_ mention of either finding or not finding these. I'll see what
>
>>
>
>> jpeg libraries I can install and then re-try (or, I've attached the
>
>> output of ./configure below in case anything pops out at you).
>
>
>
> Check below.
>
>
>
> *snip*
>
>
>
>> Here's the output of ./configure (with or without "make clean"):
>
>
[..]
>
>
>> ./configure: line 5266: freetype-config: command not found
>
>> ./configure: line 5267: freetype-config: command not found
>
>> checking ft2build.h usability... no
>
>> checking ft2build.h presence... no
>
>> checking for
>
>> ft2build.h... no
>
>
>
> Here is your problem:
>
>> disabling imlib2 support
>
>
>
> Imlib provides the jpeg reading support for TeXmacs, I believe.
>
>
Nope. TeXmacs has no support for reading jpeg directly, if I understand
>
the source code correctly. Instead of dealing with jpeg it uses imagemagick
>
to do the magic ;-)
I stand corrected. I wonder what the imlib is used for then. Only references
to it was in obtaining image size and drawing to drawable (IIRC).
>
>
You should convince yourself, that imagemagick is installed, by checking
>
the result of
>
>
> which convert
>
>
In any case you will also need ghostscript installed. Check by
>
>
> which gs
>
>
If both of them are there, I cannot help you anymore :-(
>
>
The presence of imagemagick or ghostscript does not add jpeg support in
itself. At least not for me, that is.
>
[..]
>
>
>
Best wishes,
>
>
Ingolf
--
Jani Huhtanen
TTY Porin yksikkö
address@hidden
Archive powered by MHonArc 2.6.19.